how to install gitlab community edition on ubuntu 20.04

$ su - $ Ĭheck that everything is going well by running the built-in 'Hello World' program. Even if you were already logged in, you will still need to switch to it again to reload the permissions. Replace $ USER with the actual username if you are not currently logged in with that user. $ USER variable will select and add the currently logged in user to the docking group. ? 19128 / usr / bin / dockerd -H fd: // -containerd = / run / containererd / containererd.sockĪdd your limited Linux user account to the docker group so you can run dockers without sudo. Loaded: loaded (/lib/systemd/system/rvice enabled vendor setting: enabled)Īctive: active (running) since Thu 21:10:31 UTC 32nd century ago ? rvice - Docker Application Container Engine

The output should be similar to the following. $ sudo apt install docker-ce -yĭocker should be installed now. $ sudo add-apt-repository 'deb stable $ (lsb_release -cs)' Verify the fingerprint of the downloaded key. Status: activeĪdd Docker's GPG key to your system. $ sudo ufw allow httpĬheck the status of the firewall. We also need to enable http and https for Gitlab to work. $ sudo ufw allow OpenSSHĪctivate the ufw firewall. Before we can continue to install Gitlab, we must configure it.Įnable SSH and the port we just created so we don't get locked. In our previous step we installed, ufw (Uncomplicated Firewall). $ sudo systemctl restart sshdĬlose your current SSH session and create a new one with port 6622 and reconnect to your server. Press Ctrl + X to close your file and press Y to save the changes. $ sudo nano / etc / ssh / sshd_configįind the following line and change 22 to 6622 and remove # in front of it. To do this, we need to edit the file / etc / ssh / sshd_config. In this tutorial, we will change the SSH port for the server itself. Either you can change the SSH port you use to connect to your system or you can change the port that Gitlab will use for SSH. The server's SSH is also run on it, which creates conflict. Gitlab will use port 22 to fire repositories via SSH. Some of the software above may be pre-installed for you. $ sudo apt install ca-certificate curl openssh-server ufw apt-transport-https -y Run the following commands to install dependencies. Although you can replace RAM exchange with replacement, it is not recommended as the application will be slower.īefore we install Gitlab, we must make sure that our server has some software that Gitlab will need to run properly.

How to install gitlab community edition on ubuntu 20.04